-
SENSOR - MASS AIR FLOW
2 × $298.38 -
Gasket, Cylinder Head, Standard
1 × $16.50 -
Electronic Ignition Conversion Kit Suit 43D, 45D & 59D Type Distributor
1 × $82.50 -
Heater Tap
1 × $44.00 -
Bolt, Brake Caliper to Swivel Hub
2 × $2.75 -
Thermostat Housing Stud 48mm (1.9375") Long
2 × $2.82 -
Badge (Sticker) For Brake Servo Unit PBR VH44-J
2 × $9.90 -
By-pass Hose, Standard
2 × $5.94 -
Accelerator Cable Connector
2 × $6.38 -
Mirror Fitting Kit, Right Hand
1 × $10.45 -
HEADLAMP BULB, MAIN BEAM
2 × $95.48 -
Accelerator Cable, Rover Mini, Multi Point Injection
2 × $53.74 -
Cylinder Head Stud, Short
2 × $13.00 -
Blanking Plate, Heater Tap Outlet
1 × $12.10 -
Bearing, First Motion Shaft, MGB 3 Synchro
1 × $44.00
Transmission and Driveline
- View cart You cannot add that amount to the cart — we have 1 in stock and you already have 1 in your cart.
-
$128.15
ANGLE DRIVE ADAPTER – SPEEDO CABLE
-
-
$1.95
Anti-rattle Spring
Gear lever to selector toggle
This spring sits under the gearchange plastic bush.
Holds tension and stop rattles.
Suits the remote housing (large alloy) after about 1965- The earlier one was a bit different. -
-
$14.85
Backing Ring, For C Washer Primary Gear To Crank Shaft 2/H
-
$1.65
This is a dust cover boot for either your top or lower ball joint on either drum or disc brake cars.
-
-
-
-
$3.30
Bearing Shim, Double Row Race All Minis 0.010″
Fitted between bearing retainer & gearbox case near final drive Pinion end of the gearbox.
-
-
$49.10
Bearing, 1st Motion Shaft, 4 Speed Synchro
This is the input shaft bearing that is located at the clutch end of your gearbox, this only suits 4 sync gearboxes (A & A+)
See # 21MJ1 for 3 sync box input bearing.
-
$53.63
Bearing, Differential Side
Two of these main diff carrying bearings are required in the gearbox.
-
-