-
Setscrew, Multi use
2 × $1.05 -
Heater Tap, Suit Rover Mini, Inline type 1989 to 1996
1 × $64.90 -
Bearing Shim, Double Row Race All Minis 0.010"
2 × $3.30 -
Heater Tap & Blanking Plate Gasket
2 × $0.66 -
Flasher Lamp, Front & Rear (no bulb)
2 × $14.03 -
Bearing Set, Con Rod, +0.030"
1 × $52.80 -
Muffler, Centre Exit, RC40 Standard Bore
1 × $303.77 -
Thermostat Housing Spacer
2 × $19.80 -
Brake Booster, 1.9: 1
1 × $278.25 -
Heater Tap
2 × $44.00 -
Grease Nipple Multi Use
2 × $2.70 -
Valve Cotter, Pair
2 × $9.90 -
Thermostat, 74c, BORG & BECK
2 × $19.58 -
Bleed Screw, Wheel Cylinders
2 × $2.53 -
BELT, SECONDARY DRIVE (SUPERCHARGER)
2 × $65.68 -
Accelerator Pedal Extension
2 × $38.50 -
Diesel Injector Extractor - for JLR 2.7, 3.6 engines
2 × $217.25 -
Heater Tap
1 × $53.90 -
Bearing, 1st Motion Shaft
2 × $12.00 -
Land Rover Assorted Trim Clips 280pc
2 × $165.00 -
Bearing, Differential Side
2 × $53.63
Transmission and Driveline
-
$128.15
ANGLE DRIVE ADAPTER – SPEEDO CABLE
-
-
$1.95
Anti-rattle Spring
Gear lever to selector toggle
This spring sits under the gearchange plastic bush.
Holds tension and stop rattles.
Suits the remote housing (large alloy) after about 1965- The earlier one was a bit different. -
-
$14.85
Backing Ring, For C Washer Primary Gear To Crank Shaft 2/H
-
$1.65
This is a dust cover boot for either your top or lower ball joint on either drum or disc brake cars.
-
-
-
-
$3.30
Bearing Shim, Double Row Race All Minis 0.010″
Fitted between bearing retainer & gearbox case near final drive Pinion end of the gearbox.
-
-
$49.10
Bearing, 1st Motion Shaft, 4 Speed Synchro
This is the input shaft bearing that is located at the clutch end of your gearbox, this only suits 4 sync gearboxes (A & A+)
See # 21MJ1 for 3 sync box input bearing.
-
$53.63
Bearing, Differential Side
Two of these main diff carrying bearings are required in the gearbox.
-
-