-
Heater Tap
3 × $44.00 -
By-pass Hose Adaptor, Long
2 × $22.00 -
BUSH, FRONT SWAY BAR, RANGE ROVER
2 × $55.06 -
Brake Drum Screw, Short
1 × $0.88 -
Cylinder Head Nut, Plain
2 × $2.81 -
FRONT ABS SENSOR KIT - PUMA DEFENDER
2 × $149.00 -
Blanking Plug, Various Uses
2 × $4.24 -
Carburettor Dashpot Spring, Red Band
1 × $21.51 -
Brake Disc Rotor, 8.4''
1 × $25.30 -
Rocker Arm Bush
2 × $7.15 -
Grommet, Radiator Bracket to Engine Mount
1 × $3.85 -
Side Panel Rear Quarter Right Hand, UK Mini
1 × $544.50 -
BRAKE FLUID TESTER
1 × $55.00 -
Sensor, Fuel Injector Pressure
2 × $46.97 -
Long Male Brake Nut 10 x 1.25mm Pk 50
1 × $24.20 -
Anti-rattle Bush, Nylon
2 × $12.35
Transmission and Driveline
-
$128.15
ANGLE DRIVE ADAPTER – SPEEDO CABLE
-
-
$1.95
Anti-rattle Spring
Gear lever to selector toggle
This spring sits under the gearchange plastic bush.
Holds tension and stop rattles.
Suits the remote housing (large alloy) after about 1965- The earlier one was a bit different. -
-
$14.85
Backing Ring, For C Washer Primary Gear To Crank Shaft 2/H
-
$1.65
This is a dust cover boot for either your top or lower ball joint on either drum or disc brake cars.
-
-
-
-
$3.30
Bearing Shim, Double Row Race All Minis 0.010″
Fitted between bearing retainer & gearbox case near final drive Pinion end of the gearbox.
-
-
$49.10
Bearing, 1st Motion Shaft, 4 Speed Synchro
This is the input shaft bearing that is located at the clutch end of your gearbox, this only suits 4 sync gearboxes (A & A+)
See # 21MJ1 for 3 sync box input bearing.
-
$53.63
Bearing, Differential Side
Two of these main diff carrying bearings are required in the gearbox.
-
-