-
Adjustable Front Lower Arm Kit
2 × $209.00 -
ARM, LEFT HAND FRONT UPPER – DISCOVERY 3 & RANGE ROVER SPORT
1 × $107.53 -
Revive Refill - 750ml
2 × $92.40 -
Brake Pads, Front
2 × $53.52 -
Bush, Lower Control Arm To Sub Frame
1 × $5.50 -
BRAKE WEAR SENSOR, FRONT - RANGE ROVER SPORT 7A+ VIN
2 × $9.55 -
O Ring, Fitted to Distributor Drive Housing All Pre A Plus engines
2 × $1.65 -
Windscreen Washer Jet Pump, Mini to 1971
1 × $53.85 -
Throttle Shaft, Carburettor, 1 3/4" SU HS6
1 × $23.10 -
Door Latch, RHR
1 × $155.93 -
Heater Tap & Blanking Plate Gasket
2 × $0.66 -
Long Male Brake Nut 3/8 UNF x 24tpi
2 × $2.42 -
12000 SAMURAI 12V Electric winch with Synthetic rope
2 × $1,595.00 -
Cylinder Head Nut, Plain
1 × $2.81 -
Blanking Plate, Heater Tap Outlet
1 × $12.10 -
Boot Kit, Pot Joint, Inboard CV
2 × $11.50 -
Chrome Plug, Left & Right Hand Doors
1 × $6.44 -
Ball Foot & Cup Assembly High Quality
2 × $11.00
Suspension
-
$209.00
Adjustable Front Lower Arm Kit (Pair)
One piece, forged, fully adjustable on the car lower arms (with knuckle for bushes) to allow adjustment for any camber setting required.
Sold in pairs only.
-
-
-
-
$37.40
Ball Foot & Cup Assembly, Front only
Built in 4.33mm Spacer
-
-
-
-
-
Availability: This product is currently out of stock.
Ball Joint Separator – Cup Type
Carbon Steel
Thrust nut for leverage
Jaws : 22mm W – 20mm D – 50mm opening -
$8.95
Idler Gear Bearing, 1.004″ OD
Upper Control Arm Bearing, Front Suspension
The 25.4mm wide original genuine bearing to take 19.05mm size idler gear shaft and sits in the gearbox case on early 3 synchro types and also in the early type clutch case.
-
$13.20
Bolt, Front S/Frame Tower to Body, (Dry)
Upper Control Arm Use with # 21A2694 Spacer
-
$9.52
Bolt, Mount Bracket, Engine & Radiator
Also Front Tower Bolts Hydrolastic Front Subframe
-
$3.52
Tie Bar to Lower Arm Bolt. 5/16″unf by 1.3/8″long.
Original Bolt with a special length shank for the front suspension tie bar to the lower arm. Always check this out for any signs of wear and replace accordingly.
BH605141 is the exact correct length shank but slightly longer thread if required
-