-
Ratchet Flare Nut Wrench 14mm
1 × $35.20 -
Setscrew, Multi use
4 × $1.05 -
LAMP, FLASHER REAR AMBER (NO BULB)
2 × $12.93 -
HEADLAMP BULB, MAIN BEAM
1 × $95.48 -
ADAPTOR - HEATER HOSE - WATER MANIFOLD - RANGE ROVER L322 - 4.4LTR V8
2 × $23.87 -
FILTER FUEL, PRIMARY
2 × $107.97 -
Heater Tap & Blanking Plate Gasket
1 × $0.66 -
Thermostat Housing Stud 48mm (1.9375") Long
3 × $2.82 -
Blanking Plug, Various Uses
2 × $4.24 -
Pump, Windscreen Washer - Discovery 2, Defender & Freelander
2 × $17.33 -
Heater Tap
1 × $44.00 -
Thermostat Housing Stud, 52 mm
2 × $2.86 -
DIAGNOSTIC TOOL PRO - ALL LAND ROVER
1 × $1,650.00 -
HOSE - THROTTLE BODY HEATER OUTLET
1 × $26.40 -
Oxygen ambient air sensor with Rover Mini Fuel injected
2 × $90.75 -
Apron Panel, Repair Section Front R/Hand
1 × $141.63 -
TENSIONER - MAIN BELT - 300 TDI - DEFENDER - DISCOVERY 1 - RANGE ROVER CLASSIC
1 × $95.48 -
Thermostat Housing
1 × $24.20 -
Manifold Stud
4 × $1.54 -
Diesel Injector Copper Washer Remover/Installer
1 × $93.50 -
Master Cylinder Tank, Plastic
2 × $44.00 -
Viscous Fan Spanner 32/36mm
1 × $49.50 -
TENSIONER, PRIMARY DRIVE BELT - AJ V8
1 × $66.84 -
By-pass Hose Adaptor, Long
3 × $22.00 -
Diesel Timing Kit - Land Rover 3.6 V8
2 × $605.83 -
Bolt - Clutch Diaphragm to Flywheel
1 × $7.70 -
Sensor, Steering Rotation / Clock Spring
2 × $99.33 -
Temperature Transmitter
2 × $16.50 -
Distributor Cap, Screw On Type, Rover Mini, 1992 To 1997
2 × $15.40 -
CV Dust Boot Clamp Installer with Cutter
1 × $38.50 -
PISTON ASSEMBLY- 300 TDI - STD SIZE
1 × $157.47 -
Thermostat Housing Spacer
2 × $19.80 -
Fuel Bowl Float Suit 1-1/4", 1-1/2" & 1-3/4" SU
2 × $62.15 -
Trakrite Wheel Alignment Gauge
1 × $214.50 -
SENSOR - MAF
2 × $105.33 -
WATER PUMP ASSEMBLY - DISCOVERY 1 & 2, P38 RANGE ROVER V8
1 × $96.48 -
OIL COOLER - Freelander 1 2.5L KV6
1 × $286.44 -
Wheel Stud, 55mm, Suit Mini & Moke
1 × $2.70
Transmission and Driveline
-
$3.30
Upper Clevis Pin, Clutch Arm
Standard & Verto Clutch
The pin is 5/16″ size, this secures the push rod and the spring anchor to the top of the clutch arm
-
$26.40
Suit 4.5 x 10″ and 5 x 10″ Genuine Minilites Made from 1990.
Minilite Wheels over the last number of years have had changes of ownership, and this has resulted in some tooling changes.
Fitted from Rear, 65mm hole
-
$7.15
Stainless steel sleeve nut with tapered washer (washer is not stainless)
5/8″ SHANK DIAMETER 15.1mm wide and 16mm long shaft. Sold individually
-
$5.50
Wheel Nut & Washer, Suit Minilite & Wolfrace Wheels
Through the years Minilite wheels have been made in different widths and offsets
However, they all took .625″(15.7mm) diameter lug nuts, with Varying lengths.
This one has a shank length of 11/16″(17mmm) Suits only the 5×10 Minilite.
The Shank length is a little shorter than the Latest 5×10″ MiniLite
-
$8.80
Wheel Nut for Rover Cooper 8 Spoke.
6 sided 17mm socket and not a multi sided socket Must Be Used to avoid damaging the wheel nut.
-
$9.46
This wheel nut is the original profile to fit into the sunraysia & clubman GT rims. They are in stainless steel so unlike other nuts on the market they will not have chrome falling off them the first time you remove a wheel nut.
-
-
-
$88.00
Wheel, Standard steel 13″Â Moke
New Old Stock
Limited quantity available
Sold Each