-
Fuel Pump Camshaft Alignment Tool - for JLR
1 × $99.00 -
Brake Spanner 1/4" Sq x 5/16" OE
2 × $28.33 -
Heat Inductor
1 × $1,622.50 -
Blanking Plate, Heater Tap Outlet
1 × $12.10 -
Thermostat Housing
2 × $24.20 -
Cylinder Head Stud, Short
1 × $13.00 -
Exhaust Manifold Gasket
2 × $14.85 -
Blanking Plug, Various Uses
1 × $4.24 -
Wheel Nut & Washer, Suit Mini Spares Wheels
1 × $7.15 -
Bush Kit, Lower Control Arm to Subframe, Competition
2 × $46.20 -
Diesel Injector Extractor - for JLR 2.7, 3.6 engines
2 × $217.25 -
Gasket, Cylinder Head, Standard
1 × $16.50 -
Master Cylinder Tank, Plastic
2 × $44.00 -
BRAKE WEAR SENSOR, REAR - D3/D4/RRS
2 × $16.72 -
Crankshaft Speed/Position Sensor XJ40/ XJ6/ XJR
1 × $159.50 -
Thermostat Housing Stud 48mm (1.9375") Long
2 × $2.82 -
Side Panel Rear Quarter Left Hand, UK Mini
1 × $544.50 -
Valve Guide
2 × $7.70 -
Idler Pulley Primary Drive
1 × $37.13 -
HT Lead Ignition Spark Tester
1 × $49.50 -
Adjustable Suspension Height Kit, Front, Ripspeed Type
2 × $183.70
Suspension
-
$209.00
Adjustable Front Lower Arm Kit (Pair)
One piece, forged, fully adjustable on the car lower arms (with knuckle for bushes) to allow adjustment for any camber setting required.
Sold in pairs only.
-
-
-
-
$37.40
Ball Foot & Cup Assembly, Front only
Built in 4.33mm Spacer
-
-
-
-
-
Availability: This product is currently out of stock.
Ball Joint Separator – Cup Type
Carbon Steel
Thrust nut for leverage
Jaws : 22mm W – 20mm D – 50mm opening -
$8.95
Idler Gear Bearing, 1.004″ OD
Upper Control Arm Bearing, Front Suspension
The 25.4mm wide original genuine bearing to take 19.05mm size idler gear shaft and sits in the gearbox case on early 3 synchro types and also in the early type clutch case.
-
$13.20
Bolt, Front S/Frame Tower to Body, (Dry)
Upper Control Arm Use with # 21A2694 Spacer
-
$9.52
Bolt, Mount Bracket, Engine & Radiator
Also Front Tower Bolts Hydrolastic Front Subframe
-
$3.52
Tie Bar to Lower Arm Bolt. 5/16″unf by 1.3/8″long.
Original Bolt with a special length shank for the front suspension tie bar to the lower arm. Always check this out for any signs of wear and replace accordingly.
BH605141 is the exact correct length shank but slightly longer thread if required
-