-
Thermostat Housing
2 × $24.20 -
Rocker Arm Bush
1 × $7.15 -
Setscrew, Multi use
4 × $1.05 -
BEARING & HUB ASSEMBLY - FRONTÂ - Suit BMW MINI COOPER - R50 R53 R55 R52
1 × $185.49 -
FELT, SEALING SLIDING WINDOWS - DEFENDER
2 × $86.63 -
REMOTE CONTROL - 240v 50Hz Wireless
1 × $492.43 -
Heater Tap & Blanking Plate Gasket
1 × $0.66 -
Ball Joint Lock Tab
2 × $5.50 -
Adjustable Height Suspension Kit
2 × $286.72 -
Distributor Points Set, Mini & 75, Spridget
2 × $22.50 -
CLIP-WASHER JET - HEADLAMP
2 × $4.40 -
Clutch Alignment Tool - Universal
1 × $82.50 -
Battery Cable, 134" ( 3.4036 ) Metre Long
1 × $132.00 -
Assorted Plain Steel UNF Nuts
1 × $53.90 -
Camshaft Thrust Plate
2 × $23.00
Engine
-
$12.19
Adaptor, Oil Cooler Hose to Filter
The original union that fitted on the A series block to take the oil cooler hose. Many kits now include the union as part of the hose. Filter head size 1/4″NPT.
-
$21.95
Big End Bolt, Qty 8 needed per engine
-
-
$46.89
Camshaft Bearing Set, 850 cc, 998 cc & 1098 cc
Mini’s have one of two sizes of cam bearings; 850/998/1100cc blocks use # AEC3046 which has one bearing smaller in diameter than 1275cc (see # AEC3063)
Usually fitted by a machine/engineering facility.
Spridgets and Minors have the same block as the Mini, therefore these same cam bearings.
-
$42.97
Camshaft Bearing Set
This is a standard cam bearing set for a 1275 engine (note that small bore engines are not the same) you will require a cam bearing installer to fit (or see an engine builder)
-
$23.00
Camshaft Thrust Plate, goes behind the camshaft pulley in the timing chain area.
Good maintenance, just as you would never rebuild your motor without replacing the crank thrust washers, you should also care about the camshaft thrust plate. Sometimes called the “triangle plate” this small but important plate doesn’t just hold the cam to the block, but has to locate it within the proper tolerance. There is a bearing surface on the plate, and when that wears the cam can literally walk back and forth. The point here is that any time you have the cam plate off you should replace it, as you would with any engine bearing.
-
$313.50
Clutch Kit, contains Clutch Plate, Clutch Cover, Thrust Bearing.
-
$198.00
Clutch Kit, contains Clutch Plate, Clutch Cover, Thrust Bearing.
-
-
-
-
-
-
$9.55
Cylinder Head Stud, Long (14 cm), Cooper S Spec
These Are Genuine New Old Stock
Purchased from the factory at Zetland a little shop soiled
Has the telltale dimple in the top of the Stud
-