-
CLIP - MOULDING - BODY - FRONT FLARES
2 × $1.65 -
Camshaft Sensor
2 × $55.00 -
Wiper Link Nylon Bush, Moke 2/Hand
1 × $2.00 -
Anodised Alloy Knob Set R380
2 × $97.08 -
Bolt, Remote Control to Diff Housing
1 × $1.10 -
Sheer Bolt, Steering Column Clamp
1 × $6.60 -
Bearing, Layshaft & 1st Motion Shaft
1 × $9.08 -
Brake Caliper Assembly, RH
1 × $251.32 -
BRAKE FLUID TESTER
1 × $55.00 -
Engine Timing Kit - for JLR 2.0 GTDI Petrol
2 × $434.50 -
Viscous Fan Spanner 32/36mm
1 × $49.50 -
BALL JOINT, A FRAME. ADJUSTABLE & GREASEABLE
1 × $51.70 -
Brake Caliper Assembly, LH
2 × $251.32 -
Air Pump Pulley, 1975 onwards
2 × $15.40 -
Welch Plug, 1.326" diameter
1 × $2.75 -
Brake Master Cylinder Repair Kit, MGB & TR7
2 × $77.00 -
Badge (Sticker) For Brake Servo Unit PBR VH44-J
2 × $9.90 -
BRAKE MASTER CYLINDER - SWB SERIES LAND ROVER
2 × $151.53
Suspension
-
-
Availability: This product is currently out of stock.
Shock Mounting Kit For Upper Control Arm, One Side
-
Availability: This product is currently out of stock.
MINI – Crank pulley and camshaft nut socket.
Also C.V joint nut ( PRE METRIC ) & Subframe single tower mount bolt. -
$62.43
Socket – 1 1/2″ – Deep – Single Hex – 1/2″ Drive
MINI – Top & Bottom ball joint
Also Flywheel Bolt. -
-
$1.93
Subframe Tower Bolt Washer
Rubber Cone (dry suspension), Late UK Rubber Mounting Subframe
Fitted from 1976 on rubber mounted subframes this washer goes on the large single tower bolt on the front subframe- fits on top of the standard original rubber seal KGE100050 to stop damage. Bolt is available as 21A2596.
-
$165.00
SUSPESION CONE – COMPRESSOR TOOL
-
$2.75
Front Shock Mount Upper Tapped Plate.
This plate is welded to the inner guard, The upper shock mounts are bolted to this part is Genuine New Old Stock.
-
$12.76
Tie Bar Bush Set, Poly/Rubber 4 Pieces.
The Tie Bar is the Bar or Rod on the Front Suspension that is attached to the Lower Control Arm & the other end is attached to the Subframe.
Enough for One Car
Use 2 Soft rubbers on the inside and the 2 Mauve poly on the outside.
Hard Outer / Soft Inner – Helps stop Brake Weaving.
-
-
-
-
-
$4.95
Upper Bush, Subframe Tower Bolt
Rubber Cone (dry suspension, Late UK Rubber Mounting Subframe)
-
$0.77
Flat Washer
Fits top and bottom of the front damper and the lower rear damper to keep the bush from moving in the shock absorber eye sockets.
3/8″ hole x 1″ OD (1.4mm thick by 24.6mm wide)
New Old Stock