-
CLIP-WASHER JET - HEADLAMP - GENUINE
2 × $4.50 -
Apron Panel, no mounts, Mini Aftermarket
1 × $342.65 -
BRAKE FLUID TESTER
1 × $55.00 -
CHAIN - TIMING - PRIMARY
2 × $107.42 -
Bush, Steering Column Bottom, Felt
1 × $16.50 -
Brake Fail Switch
2 × $79.75 -
Adaptor, Vent To Ducting RH, UK Model Mini
2 × $31.35 -
Blanking Plug, Various Uses
1 × $4.24 -
Master Cylinder Tank, Plastic
1 × $44.00 -
BALL JOINT, A FRAME. ADJUSTABLE & GREASEABLE
1 × $51.70 -
Distributor Points Set
2 × $6.33 -
HOSE - COOLANT
1 × $62.06 -
Battery Box, Boot Floor
1 × $257.80 -
Filter Oil, Element - AJ 2.0L
1 × $11.94 -
SENSOR HEIGHT, LHF - L322 02-09
1 × $83.55 -
THERMOSTAT 4.4L V8
1 × $48.13 -
Bush, Front Radius Arm
2 × $15.13 -
Viscous Fan Spanner Set 3pc - for Land Rover
1 × $264.00 -
12v/ 240v PORTABLE 45L FRIDGE FREEZER
4 × $1,228.15 -
KIT REPAIR - OIL COOLER
2 × $215.33 -
Tensioner, Drive Belt - 2.7L / 3.0L TDV6
1 × $150.38 -
LAMBDA/O2 SENSOR ASSY, FRONT/UPSTREAM - V6/V8
2 × $155.93 -
Rocker Arm Bush
2 × $7.15 -
Latch, Front Door RH
2 × $214.83 -
Apron Panel, Repair Section Front R/Hand
1 × $141.63 -
BUSH, FRONT UPPER CONTROL ARM - D3/D4
1 × $15.40 -
12000 SPARTAN WINCH 24V WITH SYNETHETIC ROPE
1 × $1,210.00 -
Lamp Assy Fog, Fitted To Rear of Mini Under Bumper Bar NOS
1 × $22.00 -
COIL SPRINGS - REAR - HEAVY LOAD +2"
1 × $324.50 -
By-pass Hose Adaptor, Long
1 × $22.00 -
Carburettor Throttle Disc Screw
2 × $2.31 -
Manifold Stud
1 × $1.54 -
Setscrew, Multi use
3 × $1.05 -
400 amp snap connectors.
2 × $60.81 -
Coolant Temperature Sensor
2 × $33.83 -
HSING & T/STAT (82c)
2 × $64.80 -
WINCH - SPARE WHEEL - CARRIER
1 × $131.29 -
Blanking Plate, Heater Tap Outlet
1 × $12.10 -
INTERCOOLER SILICONE HOSE KIT DISCOVERY 2
2 × $137.50 -
Steering Wheel, Leather
1 × $199.65
Steering
-
$0.77
Steering Rack Damper End Gasket
The same end as the Wave Washer # CCA45 is fitted
-
$0.66
Steering Rack Gasket, Damper End
The same end as the Wave Washer # CCA45 is fitted
-
$38.50
Steering Rack Pinion Bearing
Inside Steering Rack
-
$1.65
Steering Rack Wave Washer
This is a steering rack pinion wave washer, there are two of these that hold a preset tension against your pinion (load). If one of these are broken, it can make the steering a bit loose.
Please note these only fit the original steering rack (not the new UK ones).
-
-
-
Availability: This product is currently out of stock.
Tie Rod End, Steering Rack, Competition
With grease nipple, Longer track rod end for when running with negative camber, an extra 5mm of adjustment approximately over the standard item.
Sold Individually
-